VAG 11.11.2 latest version, can use the sofware only 11.11.2,It works with all VAG vehicles including VW / Audi / Seat and Skoda from 1994 to 2012; this includes new VW / Audi and Seat
The professional`s interface you need to turn any PC with an available USB Port into a powerful diagnostic tool for VW, Audi, Seat or Skoda automobiles.
A 1 GHz Pentium-III (or AMD equivalent) with 256 MB of RAM and or newer (XP, Vista or with an available USB port. With Windows Vista or 7, use a machine robust enough to properly support the operating system.
Lastest version: 11.11.2
VAG 11.11.2 diagnostic cable Supports Measuring Values, Output Tests, and Adaptations on control modules using the new UDS/ODX/ASAM protocol.
Adds new UDS addresses and updated ODX data for 2012 models.
Includes support for TP1.6 protocol which is required for the 6J Ibiza and speeds up access on many modules in other models.
The Select Control Module screen now shows "Installed Modules" rather than "Common Modules" if the car being worked on is new enough to have a proper CAN Gateway.
Modified SRI Screen to show more info and force user to select a job before proceeding.
Adds drop-box function selection in Basic Settings and Adaptation.
Reads Mileage stored in many EDC16 ECUs.
New CODES file, now with over 13, 000 fault code and measuring value texts.
New USB drivers for enhanced PC compatibility and stability.
New firmware for HEX interfaces required for compatibility with 6J Ibiza
Updated Label files; Better documentation for new and existing models.
1PC x VAG 11.11.2 cable
1PC x CD software
Run it and follow the prompts to allow it to install itself.
You must install it on your PC's hard disk!
It may not work properly if you try running it directly from other media.
However, you can use other media such as a CD or USB memory key to move the distribution file from a PC with internet access to another PC that does not have internet access.
Connect an appropriate interface between the computer and the car.
Turn the car's ignition switch ON. No need to start the engine.
Start the program:
Click [Options] and select the correct communications port.
Use [Test] to confirm that the program can use the port and find the interface.
Now Play. Make sure the software can reliably access all the control modules that it should in your car. See ourApplication Charts. Query Fault Codes from some modules.